Supposedly you can go to 100k, but 60k is more conservative. If you have money burning a hole in your pocket, go for it.

 

Just got my teg, and I'm replacing them just for the hell of it....car has 104k miles, and wires look original.

BTW, I just recieved my NGK wires from NOPI....at 35 bucks, I thought it was pretty good deal. If dealer tries to pull a fast one on you (they always do

), might wanna check them out.

 

get a multimeter and test the wire resistance according to spec

 

I bought Accel 8.8's for my car look nice and perform nice as much as I can tell!
Nick

 

Supposedly the stock Honda wires outperform or perform equally to every aftermarket ones except MSD.

BTW, you won't be able to tell any difference with more expensive plug wires and/or plugs.

 

well the original factory will last for quite a while, i didnt replace mine untill like 130,000, and they worked pretty good even then. but if you have the money go ahead and replace them, i personally bought some accel 8 mm the kind where you have to cut the wire and put on the connectors yourself, which it was pretty easy. and the kit i bought will due 8 plug wires so you wont have to buy anymore for a while, i think it cost like 50 some odd bucks....

 

oh there is one draw back to this route is, is that if you notice there is rubber grommets on the factory ones that plug the holes, and there isnt with these, so i just bought some round rubber grommets and made them fit and work all the same..

 

Anyone know what the specs are for acceptable wire resistance? That's the first thing that came to mind, but I don't know what numbers I should be getting.

 

<25,000 ohms at 65F. any greater and it needs to be replaced.

 

I have a 94 gsr and I checked my wires and they're stock. The car has 152,000 miles on it and it runs fine...but I know that I should replace the wires. I was thinking of hks vitek or nology. PPL say wires are all the same...and some ppl say that you get what you pay for...so does anyone know which wires would be the best to get? Also would you replace the dis cap with it...seeing that it only costs $20 for a new bosch one?

 

I would only get the stock Honda ones or MSD. I'm not sure on Bosch wires, but I'll assume they're good. Don't get crap like Nology or whatever.

 

Stock wires are one of the best.