Team Integra Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
i've tried searching but no luck, i was wondering if the type r and b16 rods are the same? i was reading and they have the same part number PR3? but not sure, can someone clarify if they're the same or different?
 

·
Registered
Joined
·
49 Posts
Discussion Starter · #3 ·
i was also wondering if i would be able to use Type R or b16 rods on a GSR crank, I saw a TI member put a gsr crank with type r rods in an ls block, I was told that you can't put type r or b16 rods on a gsr crank?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top