[MorningZ]

tweeter size thread

if i hook up the front channel to the speakers, AND tweeters...assuming they are all 4 ohms, wont they be wired to be 2 ohms??

no, impedence is a concern for speakers at the same frequency (importance of a good passive crossover network).. anyways, you can wire many tweeters to a 4 ohm load and it won't affect it too much (will change the crossover frequency of the crossover though

 

[MorningZ]

I don't have an amp for the front speakers...I just
want to know if it's ok to wire the tweeters in parallel
(piggyback them) with the door speakers?

thats fine to do

 

[MorningZ]

if that was going to be an issue, i would not have recommended that you can do so..... which was on the assumption you were planning to wire in the crossover for tweeters as well

 

[MorningZ]

they are 3/4" tweeters, but you can squeeze 1 inch tweeters in there (check out the component installtion article)

 

[MorningZ]

you can use either one....