Team Integra Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I just put back in a transmission in my 2000 Integra LS Skwa auto with a used skwa. Got everything in and went to start and it cranks but no start. I have no spark. My key light doesn’t light up neither does my cel/mainreq and oil light when i have the key turned. Had the car sitting for a little over a mount.
 

· Registered
Joined
·
14 Posts
Discussion Starter · #5 ·
Going to take a look during the daytime, i checked the one 15amp under the hood and it was good. The small ground cable that bolts onto the transmission with a little mount the mount doesn’t look like a good contact so going to take a look at that tomorrow.
 

· Registered
Joined
·
14 Posts
Discussion Starter · #7 · (Edited)
I have power in the fuses and changed the ground cable used a wire brush clean off both contacts. I unplugged the distributor connector to see if any power but only one has power not sure if thats and same when i go to start no power either
 
1 - 6 of 6 Posts
Top