Team Integra Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I was replacing the bushings on my suspension and saw a lot of talk about the rear bushing tool and clamps and secrets and tips, but no useful pictures. So, here's a pic of the tool set up with the 8" C-clamp to prevent the tool from pulling the trailing arm apart rather than pushing the bushing. Worked with no problems. Stand back when that thing pops loose, though! Wow, the whole arm jumped off the workbench, make sure you use the safety wire to retain the bushing.

 
1 - 1 of 1 Posts
Top