[wild_crx]

Hi, can anyone help me out here, I just put in a B16a2 in my 92 integra ls. The car is running fine, but my vtec is not working, also my check engine light is on, and when I try to do the Check engie light, diagnostic, my light does not blink. I jump the blk/brwn wire together and turn the ignition to on. Anything will help, im about to give up.

thanks for the info.

 

[ynotlim]

have you changed your ecu yet ? there is a primary and secondary vtec swtich, if your ecu is for the ls engine, it wont kick in b/c you dont have the rite ecu.

 

[TeamKinetik]

who did the swap for u??dont tell me you did it yourself

 

[Gensavestheday]

eww pay someone ELSE To work on your car?!!?!? I think not...

 

[Jacksont001]

swapping in a b16 requires more than just the engine, you need the electronics too. you could also bypass the ecu by using a VTEC controller or even wiring it up off of a shift light.
if your VTEC wiring is done properly then your oil pressure is too low. make sure it is filled to the top line of your dipstick.