Team Integra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hey, i just got a new speedo cable, for my 91 integra LS and cant figure out, for the life of me, how to get it to work...i got the part plugged in the guage cluster, and the cable is run threw the firewall, and then the other end is somewhat in the transmission...but i dont know how to get it to calibrate, or get the end to stay in the tranny...any pics or how to's would be nice.....Thanx a bunch!
Peace
 

·
Registered
Joined
·
51 Posts
The end going into the transmission has to be pushed all the way down, far enough that the retaining clip locks the cable end into position. If it doesn't go ALL the way down you get no readout, been there, had that happen to me. If the other side is connected to the speedo gauge properly, there is a good chance it's just not all the way down inside the tranny.
 
1 - 2 of 2 Posts
Top