Team Integra Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
7,837 Posts
Discussion Starter · #1 ·
I know I saw an article on how to do this, but I can't find it, maybe it was another board.

It involves a bat and I need to do this to stop minimal rubbing because I just got a 1.7 in front and 1.5 in rear drop and when I take certain corners I can hear it rub.

thanks
 

· Registered
Joined
·
7,837 Posts
Discussion Starter · #4 ·
I understand that, I just wanted to know a step by step process, so I dont bend anything too much, I know I've seen an articel just wanted to know if anyone knew where.

I'm not just going to whip out a bat and start bending without further knowledge.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top