Team Integra Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
hey all!!

i'm going to be pulling my moulds off my 3 door Integra over the weekend to paint them with PlastiDip, just wondering if anyone has removed them before and can be of assistance?

mainly the ones around the top of the doors and the bottom sill of the rear side glass


thankyou!!!!
 

·
Registered
Joined
·
76 Posts

·
Registered
Joined
·
76 Posts
Yup, that's what I did. I cut the old plastic molding off with a razor blade then taped as close as I could, then put up newspaper and taped it down, so there would be no way for me to miss and spray glass or paint. I did 3 coats and let them sit 10 minutes between coats and 24 hours before driving to fully dry, though it was dry 3 hours in the sun.
 
1 - 5 of 5 Posts
About this Discussion
4 Replies
2 Participants
Metal Slug
Team Integra Forums
The Team Integra community is a forum dedicated to Acura Integra enthusiasts to discuss engine building, suspension, repair, detailing and anything else Integra related.
Full Forum Listing
Top