Team Integra Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
couple months back, i had a little "curb" incident, ben the control arm and had some serious negative camber. took it to the frame shop, they replaced the twisted part in the control arm and bent it back about 80 %, then had alignment done and they did as much as possible. It's not even noticiable at all now, but i ve noticed wear on the very inside of tire, my question is what to do, take back to frame shop, buy camber kit?, or what? thanks for your help
 

·
Registered
Joined
·
5,381 Posts
The control arm was twisted back into place as in they tried to unbend it? Or was it replaced?
 

·
Registered
Joined
·
277 Posts
change the control arm or it could be the axles.
 
1 - 3 of 3 Posts
Top