Team Integra Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
Alright guys, i just took my motor down to the shop saturday and was wondering what other people are getting out of there similar setup. Here goes:

AEBS sleeved bottom end
Eagle rods
85mm CP 12.5:1 pistons
Buddy club or Brian Crower stage 4 cams
titanium springs and retainers.
Skunk 2 IM
Six sigma racing header
hondata S200
440cc injectors
walbro 190 lph fuel pump
short ram with velocity stack
all tuned on 93 octane

Was wondering what others are putting to the wheel and what they're running in the quarter mile. Everyone's answers will be appreciated. Please dont post any bashing comments.
 

·
Registered
Joined
·
6,638 Posts
Theres no way for anyone over the internet to guess what horsepower you will get from a given setup. Put two engines with the exact same setup side by side, and they might produce different results.

Theres also no way at all anyone can guess your 1/4 mile times, WAY to many variables there. From power output, driver, traction, temp of the tract ect....

The only way your going to know how much power you make, is putting on the dyno.

The only way your going to know how fast you can go in the 1/4 mile is to go run it.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top