Team Integra Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
hey guys i ripped out the entire rear section of my car, my seats are out and all the plastic panels. I have a bunch of dynomatt that i was planning on putting in the trunk and on the sides and on the wheel wells, but it seems like there is going to be a whole lot of cutting involved. If someone could post some pictures of dynomated integras or tell me some good ways to go about it i would greatly appreciate it.
 

·
Registered
Joined
·
2,166 Posts
What i did was, i first layd it down like the whole layer, and then took a marker and outlined all like the curves, and grooves and what not,then i went ahead and cut the pieces and when u  put it on theres this roller that u can use that make it easy to put on there, sorry no pivtures though
 

·
Registered
Joined
·
349 Posts
A heatgun or blowdryer will help you to mold it =) here are some pics... hope they help!





 

·
Registered
Joined
·
3,477 Posts
Goodness. How much did you spend on all that Dynamat?
 
1 - 5 of 5 Posts
Top