Team Integra Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So I just recently bought an integra and it has an obx exhaust on. The car has a very very loud low rattle during certain rpms. I was feeling around by hand and I think it's because the axle back is mounted too tight up against the underside that it causes the loud rattle. Not sure if it's because of just that brand fitment or what. It also has a silencer that's stuck in it. I was thinking of just buying a Mugen twin loop to solve both rattle and silencer problem.

My question is, my goal from the start was to kswap eventually. Does kswap exhaust differ from bseries exhaust? Like if I get the Mugen twin loop and then k swap later, would I still be able to use the twin loop?
 
1 - 1 of 1 Posts
About this Discussion
0 Replies
1 Participant
SteveV
Team Integra Forums
The Team Integra community is a forum dedicated to Acura Integra enthusiasts to discuss engine building, suspension, repair, detailing and anything else Integra related.
Full Forum Listing
Top