Team Integra Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Recently did a b18b swap auto to manual in my integra, engine ran good 130k on it before swap. After the swap It started for a couple of minutes and went for a spin ran ok. I came back home made sure coolant was full and it shut off and could not get it running again. Checked spark it had no spark but had fuel. I replaced my dizzy and spark plugs and had spark and fuel again with the auto ecu. Now I cannot get it to start. The reason I’m not using the manual ecu is cuz it has an immobolizer not allowing it to start. So now I’m stuck and can’t get the car running again. Any suggestions?
 
1 - 2 of 2 Posts
Top