Team Integra Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter #1
Whatsup everyone. I bought a aftermarket lip on ebay, a bayson r type r front lip. I test fitted it and fits pretty good. I looked up how to install a front lip and i found that most of them are for the 94-97 integras. I dont want to just put 4 self tapping screws on the side. I want it a bit more secured and theft proof just for my peace of mind. I read the threads attached on the bottom but they are for the 94-97 integras. I have a 2000 integra ls hatchback. My front bumper is a bit more different on the bottom. The 94-97 holes where the front lip attches are faced sideways in the articles. Mine faces forward. Is it better if i use the clip nuts or just the bolts? Also some of the pics are missing which includes some hardware which i was curious what else was missing. THANKS!

http://www.team-integra.net/forum/19-projects-diy-article-talk/87576-itr-lip-installation.html

http://www.team-integra.net/forum/19-projects-diy-article-talk/157880-how-install-aftermarket-type-r-lip.html
 

·
Registered
Joined
·
208 Posts
iirc alot of people use the 4 screws and 3m emblem tape along the long areas, but i may be wrong.
 

·
Registered
Joined
·
355 Posts
1. I used 2 self tapping screws, on the of the tire fender wells,
2. one screw in the middle (under/behind) the license plate,
3. 1/3 of a swimming pool noodle (3 feet long), wedged between the bottom of the lip and the original bumper.
I did this in 2003, to my 2000 LS and it's retained its shape and position.
 
1 - 6 of 6 Posts
Top