Team Integra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,619 Posts
Discussion Starter · #1 ·
ok so i have been working to put some new rear calipers on and finally got done tonight. the thing is they seem to not be letting up. i took it around the block and the brakes were smoking when i got back, mostly left driver side.

i had a problem getting the e brake bracket off the old caliper on that side so i cut the bracket and connected it to the new caliper thinking that it would be fine since the way it was designed. i got it back in the garage and unhooked the ebrake clevis pin and same thing. any ideas? the calipers were tight going on and i did bleed them...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top