Team Integra Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hey guys,

So I was doing one of these BS alternator replacements and ran into a little snag. I did everthing by the book, took it out the bottom, removed the control arm etc... But now I for some reason I just can't get the lower control arm back into it's rightful place. I tried using a jack and everything, I can get it high enough but I just can't pull it in towards the joint, (more or less it fans out about 15 degrees too far). Any suggestions!?!

Thanks guys
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top