Team Integra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9,719 Posts
one measurement

Aside from that, I can't really tell you. If you really just need one, why don't you go out and measure your current one so you know?

Someone needs to do this and confirm the sizes. It would be nice and very helpful. It would be gladly added to the common topics if it did happen.

Here, I'll start it up. I have center caps from the Mesh OEM alloy wheels in front of me. They meaure ~ 56.mm on the inside and 57.85mm on the face.

That comes to about 2.2" on the inside and 2.275" on the face.

The ones that I have are for the 15" mesh wheels, however they look just like the ones being sold here.
 

·
Registered
Joined
·
9,719 Posts
Thats pretty close to mines. I rechecked mines and you seem to have measured it from the face itself whereas I measured mines from the OD of the cap itself. Same thing, but at different locations.

Those measurements are correct. so make sure you get the ones that fit.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top