Team Integra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
101 Posts
Discussion Starter · #1 ·
im running a JRSC @ 9psi and want to get the car from my house to the dyno with the 440's on so i could save on labor. i am going to take off the JR FPR and the JR IAT resistor and install the 440's @ home. also i am running a EFI PMS so i could take away some fuel in increments of 2% at different load and RPM settings. the car is a 2000 GSR.

What amount of fuel should i take away in a % and is it that much at all loads(low-high) and RPM's(idle-6000). i figure only low-high and untill 5k RPM because i am going to baby it to the dyno.
 

·
Registered
Joined
·
3,882 Posts
-40% fuel across the board should get you to the dyno. just don't boost it, of course.
 
1 - 2 of 2 Posts
Top