Team Integra Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Can anyone send me a pic of the wiring for the ECT/TW sensor (temperature for the ECU, two pin connector above tranny on side of the head under the distributor)? Or which color goes near the release squeeze lever and which away.

My wires snapped off and I'd like to get the correct wire onto the correct pin of the sensor. They are green/something and red/white.
Car is a 94 RS - but I'm hoping the wire colors are consistent across obd1... Since Im pretty sure the engine harness is out of a vtec something.....

Light Product Automotive lighting Auto part Gas
 

·
Administrator
Joined
·
4,404 Posts
For anyone else that gets here, thank nuke for the PM. Red towards the release lever.
Thanks for following up with this. I'm not a fan with members answering questions within a PM instead of within the actual post. It doesn't do any members in the future any good if the same question pops up. Additionally, most people don't come back in with the answer such as what you did. Thanks for following up!!
 
1 - 3 of 3 Posts
Top