Team Integra Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
on the front of the engine block is a flat pad with the engine code B18B1) and a serial number. Is this serial number supposed to match the tub VIN?
 

·
Registered
Joined
·
1,435 Posts
yes the engine vin number should match that on the dashboard - (unless you've swapped interiors like i did...)
 

·
Registered
Joined
·
2,975 Posts
no, the serial numbers below the B18** number on the block do not correspond to the vin number on the chassis.

however, if you have a 96+ teg, there are green vin plates on the trans where it mates to the engine and on the engine next to the a/c compressor. these plates should be identical to the dash board vin plate.
 

·
Registered
Joined
·
3,087 Posts
there is also an identification placard inline the driver's side door =p




~P2P
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top