Team Integra Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
441 Posts
Discussion Starter · #1 ·
Alright i need to adjust me clutch pedal height its at about 6 inchs right now with the switch part unscrewed up to the nut the pedal is basicaly pushing against the nut that holds the switch. I need to have it out another 1/2 inch but i dont see any way to do that? Need help asap.
 

·
Registered
Joined
·
463 Posts
Are you saying that the clutch pedal is too low causing the clutch to be slightly disengaged? How did this happen? Was there some sort of damage recently?

If you already fully backed out the adjuster bolt at the top...

There's a little bit of adjustment in the push rod/clevis bracket. You'll have to take out the cotter pin and remove the pedal pin. Then loosen the jam nut and rotate the clevis bracket so that it bottoms out making the push rod shorter.

Good Luck!

Personally, something sounds wrong if the adjuster bolt is totally backed out and it's still throwing out the clutch.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top