Team Integra Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
654 Posts
Discussion Starter · #1 ·
Wasup everyone, me again. Hopefully epy knows something about this too since he is all knowing. lol, j/k, no im not. Anyway, I bought this blue valve cover from ebay and its sitting in my house right now. Im waiting for it to get warm over here so I can install it in my motor. Now to the question. When i opened the box there was a set of instructions inside. It said to "make sure that you clean the valve cover properly to remove the remnants of any thing left of the machining process". What do I clean it with? Anything special I should know about the cleaning process? Holla at me and let me know. Thanks.

Btw here's the link for the valve cover. Enjoy!!!
Ebay gsr cover
 

·
Registered
Joined
·
280 Posts
its more of just a rinse with some soap and just take a good look at it to make sure there is no metal flakes lying around the inside and make sure you clean where the gasket sits so no sand is stuck and starts a leak.
 
1 - 4 of 4 Posts
Top