[chimchongdlight]

ok so heres the thing..i just did a 92-93 bumper conversion on my 90 LS..the thing is..my old bumper had so much rust on the bolts that i had to grind off all the bolts off of the bumper guard..now i have to go and buy 9 bolts from the dismantlers..is there any alternative to this problem?

 

[midnightkid]

a welder

 

[bigacuralvr]

Home depot. if you go to acura, they will give you the bolt/screw size ie: 6x24mm. Then go to home depot, spend an 1/8 of the money you would have at Acura...anmd have the same end result.
Brett.

 

[chimchongdlight]

thats a good idea..but what if i need to take off the bumper in the future?

 

[chimchongdlight]

what kind of bolts?..does home depot have replica bolts like the stock ones?

 

[bigacuralvr]

read my post, I edited again.

 

[chimchongdlight]

that sounds good man...so is that the measurements for the screw?..whats the size of the bolt that goes underneath?

 

[tsqualers]

Check out acuraautomotiveparts.net for a diagram with the bolts u are looking for and the price for each of them.

 

[chimchongdlight]

at the ends of my bumper..there slanted..like there not mounted or bolted onto nething..i dont think i have the clips on the fenders so i was wondering if there was another way? bc i dont really want to spend ne more money on the car bc im selling it after i get all the bodywork done.