Team Integra Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
ok we just finish a ls/vtec swap.The first drive i go a round the block and get a bad wobble.my friend didn't tighten the wheel lug nuts.i tighten them and check the rest.next drive i go down the block and i stop a the end of the block.I hear pop then i let the clutch out and realize the cv is out.i have not remove it but the only it seems wrong is the cv joint pop out.I am going to put it back tommorrow.The question i have is there anyother reason it rejected the cv joint other than my wheel wasn't tighten all the way?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top