[ryand]

any suggestions on teh 3 bolts holding the rotor on. I read the tech article but it said nothing about pre-treating. I don't have an impact hammer and this my 1st integra.

 

[timmy8151]

I just used a #3 phillips head screwdriver to take it off. The key to taking out these screws is getting a screwdriver that fits right.

 

[ryand]

It came off with a little elbow grease?

 

[timmy8151]

It came off with a little elbow grease?

Yeah, that's all it took for my screws. once you get them off, you really don't need to put them back in. I put my back on, but I put some anti-seize on them.

 

[98integraLs]

go to sears and get an impact driver for $20, it makes life MUCH easier.

 

[LT6916]

the impact driver is a must to get those pesky screws out.

 

[ryand]

thanks alot

 

[allb18b]

spray a lil pb blaster on the screws,smack the rotor around where those screws are a few times with a hammer them take a phillips that fits the screw perfectly and tap the back of the handle on the screw driver and turn...got mine right out this way...

 

[MeltMan]

spray a lil pb blaster on the screws,smack the rotor around where those screws are a few times with a hammer them take a phillips that fits the screw perfectly and tap the back of the handle on the screw driver and turn...got mine right out this way...

Yeah, they take a little coaxing with a big huge hammer. Mine came out this way fine too...