Team Integra Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Fuse is good and all lights are good, tried a new flasher, tried a different Hazard switch and still no flash.


Anyone have a wiring diagram of the Turn Sig Circuit ?


Thx for any info.
 

·
Registered
Joined
·
1 Posts
So question, essentially I have somewhat the same problem. Someone wired in a jank jdm front and burnt out the turn signal flasher to the point it had a whole in the relay, replaced that replaced the burnt wires traced them back and they have continuity. I don’t have the dash in right now but I tried to test the lights and most of my lights are now working. But the turn signals arent. Do I have to have the dash in with the hazard switch in order for them to work? That’s what I’m understanding from the diagram above. Please any help is appreciated
 
1 - 4 of 4 Posts
About this Discussion
3 Replies
3 Participants
Soliveros15
Team Integra Forums
The Team Integra community is a forum dedicated to Acura Integra enthusiasts to discuss engine building, suspension, repair, detailing and anything else Integra related.
Full Forum Listing
Top