94 integra h22a swap will crank but wont start
Join the discussion
Recommended Reading
-
B18C SiR-G swap help
Advanced Tech CornerHey there, this is my first post ever in the community. So my intentions for my 2000 Acura Integra RS is to have completely stock GSR internals. I've come across a JDM B18C being sold for a really good price. It's the entire swap being sold to me. Long block, transmission, ECU, etc. I'm planning...- 0
- 32
-
Help needed, badly.. - '93 Integra JDM B16/GSR head
Advanced Tech CornerHey guys, I'm a new DA owner. Just picked up a '93 RS as an incomplete project, it's got a 1*** serial number 1st gen si-r block, p72-2 gsr head with the matching manifold. I can see now why I got this car so cheap, and I really want to rescue it. I need help figuring out what needs to happen...- 0
- 66
-
da9tay_p · updated
-
NeverEnding brake fluid
Advanced Tech CornerSymptom : Adding 12 fluid oz every 2 days brake fluid. Observation: brake pads are fine front and rear no leaks visual inspections of entire system. I fear catastrophic failure. What can possibly be wrong only the experienced can answer this question. With my gratitude in advanced. 1994 Integra.- 4
- 166
-
Gabriel zila · updated
-
Transmission swap help needed
Advanced Tech CornerI have a skwa transmission that went bad. I went to a recycle yard and they told me a s4xa transmission would swap with it no problem. When i got it home and started prepping the transmissions, i noticed a cable on the s4xa that the skwa doesn't have. Then there's more sensors on the skwa than...- 0
- 121
-
Edv1971 · updated
-
Drive shaft ?
Advanced Tech CornerHow do I pop the halfshaft out the part that comes out of the transmission and into the CV axle I need to replace the seal- 0
- 101
-
Estevan · updated
Join now to ask and comment!