Team Integra Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
305 Posts
don't need it. I did the bumper swap years ago and it was a total bolt up
 

·
Registered
Joined
·
1,942 Posts
The only thing u will have to modify will be ur 90-91 styrofoam so it can fit on the 92-93 bumper. The rest is a direct fit.
 

·
Registered
Joined
·
305 Posts
no, it is a bolt on, but yes the styrofoam does need to be cut just a little.
 

·
Registered
Joined
·
273 Posts
ok i had the same problem with my styrafoam..but i simply took it off and its holding fine..the only thing..is the sides..it slants down..i dont kno whats wrong..i think there are missing brackets where i have to clip onto the bumper..but on my old one i dont think there were any brackets..and it held..so im still trying to figure it out..i dont really wanna buy the clips..those brackets look weird..i've never seen those before..
 

·
Registered
Joined
·
129 Posts
someone correct me if im wrong, but i think those are for the jdm bumper support. I recieved my jdm support with brackets that looked exactly like those.
 

·
Registered
Joined
·
1,546 Posts
Discussion Starter · #10 ·
when i did my conversion it didn't fit perfectly even with modifying the styrafoam. BUT if you use the bumper support and the brackets of a 92-93 it'll fit perfectly.
 
1 - 10 of 10 Posts
Top