Team Integra Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I swapped my integra with a jdm b18c. The car strong and pulls hard but wont go past 6500 rpm. I have a code 21 for vtec but my vtec engages as it should and pulls but wont go past 6500 rpm. I am using the stock p73. I swapped ecu with a chipped p28 and still same thing.
 

·
Administrator
Joined
·
3,770 Posts
Did you check your vtec solenoid an make sure it is engaging? Sometimes the screen gets jammed up
Just an FYI....

This thread is almost 1yr old, and the OP hasn't logged back in since last July. I doubt he'll reply.
 
1 - 3 of 3 Posts
Top