Team Integra Forums - Team Integra - MeltMan
Old
Rating: 7 votes, 5.00 average.

Advanced Ignition Troubleshooting

Posted 11-18-2005 at 06:18 PM by MeltMan

This article is intended to help those who have no ignition and are throwing no error codes.


Tools required

- Phillips Screwdriver
- Digital Multi-Meter
- 12-Volt Light Probe
- A friend

Start by removing the 3 rotor cap screws:



Next, we remove the rotor. Do this by first removing the...
MeltMan's Avatar
Super Moderator
Posted in Engine
Views 65652 Comments 6 MeltMan is offline Edit Tags
Old

G3 Rear LCA Shock Bushings Removal/Installation

Posted 10-26-2004 at 09:44 PM by MeltMan

This article is a suppliment to the G3 Coilover/Shocks/Springs Install article by MorningZ.

It is meant as a guide to help you if your rear installation goes bad, as many of them do.

It is a DIFFICULT fix and should only be attempted by those who have the necessary tools, time, and mechanical ability.

Tools required:
* Milwaukee Sawzall and metal cutting blades
* A MINIMUM of one additional person
* Wheel Removal Tools
*...
MeltMan's Avatar
Super Moderator
Views 10341 Comments 2 MeltMan is offline Edit Tags
Old

Interior Neon Installation

Posted 06-07-2003 at 09:00 PM by MeltMan

The following article is a method to install neon tubes to light up the interior floor area in out Integras

Tools needed:[*]Phillips screwdriver[*]Soldering iron with solder[*]Lighter[*]Drill and small drill bit[*]Dremel & cut off wheels[*]Hot glue gun[*]10mm socket

Other needed materials:[*]Neons (I used 10" neons)[*]Wire (14-18 gauge is fine)[*]Aluminum L strip (short) from home depot[*]Heat shrink tubing[*]Electrical tape[*]One 5A automotive fuse and holder[*].25...
MeltMan's Avatar
Super Moderator
Posted in Appearance
Views 10869 Comments 0 MeltMan is offline Edit Tags
 
For the best viewing experience please update your browser to Google Chrome