Team Integra Forums banner

SoCal 1995 DB8 5 Speed $4,000.00

CA 
3K views 1 reply 1 participant last post by  randsmurf 
#1 · (Edited)
http://s558.photobucket.com/user/909Stitch/slideshow/Mobile Uploads/1995 DB8 ACURA INTEGRA
1995 DB8 Integra 4 door
drivers side wheel well / shock tower spot welds broke (possibly can get a used one and get it welded in)
167k on body
B20 high compression
USDM Type R Transmission
Custom Stereo Clarion DVD flip screen player and Trunk Enclosure
Shaved door handles on all 4 doors
JDM Front with new non hid chrome lights
98 rear bumber
JDM type r rear spoiler
Extra Parts Included
Original GSR engine
Original Tranny (rebuilt)
98 USDM front
2 USDM Hoods
USDM Fenders
JDM chrome headlights
JDM floor mats
JDM srs steering wheel
JDM cluster
JDM center console
additional JDM type r spoiler
98 USDM all red tail lights
94 USDM tail lights
18" Axis white touring cup w/ blue center caps
18" ADR white Mode 4
Full Urethane Bushing Kit
Hondata S200b

used turbo setup
Turbo - Turbonetics T3To4e .57 trim turbo with .60 ar cold and .63 hot
comes with both inlet oil fitting as well as the dump oil fitting. Polished compressor housing as well. Spins freely no play at all. 5 bolt flange.
Manifold - RevHard cast manifold NO CRACKS.
Wastegate - Tial 38mm comes with 5 psi spring. Have gasket for wastegate to manifold along with a dump tube flange and short dump already put in play.
Blowoff- Greddy type S (purple top)... this unit is clean not too loud at all.
Downpipe - 2.5 inch with two O2 bungs and a flex pipe at the bottom. It has cracked in the past, and was welded. It also has a small dent in the bottom... Honestly its not the prettiest thing in the world but it gets the job done and if your looking for a cheap downpipe to get started with its perfect. 5 Bolt flange.
Intercooler- RevHard 26x8x3 unit.
Chargepipes- All custom made madrel bent pipes. 2 inch on the hot side and 2.25 on the intake side. The intake pipe obviously has a flange for the Type S blowoff.

Injectors- RC Saturated 440cc injectors. Comes with OBD1 pigtails for those that need to convert their harness.
Fuel pump- Airtex inline fuel pump... same pump used in the Drag kits.
ECU- P28... chipped with locking lever and fitted with a UBERdata chip. The unit has been setup with a basemap for a GSR running the 440cc injectors. Its a very conservative map and can be used to get your car running on these injectors. I dont recommend you go to the track thinking you will run 11's with this map but it will get you by till you get a tune for your individual ride. Uberdata for those that dont know is a version of stand alone management that has the same tuning capabilities of Hondata and Neptune...
 

Attachments

See less See more
10
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top