Tools needed:
- Soldering iron
- Solder
- 4.7 pF 50wvdc maximum Electrolytic capacitor (purchase this at radio shack)
- Turn signal relay 90-00 Acura Integra
First thing is to located the turn signal relay inside of your Intergra. I do not have a picture for the 2nd generation Integra location, but it is the general location as the 3rd generation Integra.
Remove the box from the vehicle. The box looks like this once its removed completely
You’ll need to open the box to look at which capacitor your going to remove and then replace with the other.
You want to remove the capacitor that is boxed in yellow, which is the second one or the one in the middle of the relay. I would use the soldering iron to heat up the solder and loosen the capacitor, so you can wiggle it free. Just be patient it may take a few mintues
This is the view from underneath the relay to give you an idea of which one your going to remove.
This is what it’ll look like when the capacitor is removed from the relay. Next step is install the 4.7 50wv from radio shack in its place. All you want to do just stick the pins thru the holes where the old one was at and then solder it down. Once complete cut off the ends of the capacitor and put the cover back on the relay box and your 99% complete. Return back to your vehicle and now plug in the relay box and turn your hazard lights or turn signal on and it’ll look like this
(picture of everything put together before the cover is on)
video:
Video
|
Posted 7/21/2008 3:41:06 PM
| 
Back to Top